TR Self Stripping Liquid Release Gallon. Directions: On a clean surface apply a small amount with brush, spray, or cloth. Be sure entire area is covered. Allow to dry and brush or wipe off. Excellent on nonskid, grained or sand type finishes. Repeat as required. Liquid mold release is recommended for use on fully cured, well conditioned. PRODUCT: TR SELF STRIPPING LIQUID MOLD RELEASE AW RNING: FLAMMABLE Harmful or fatal if swallowed. DO NOT induce vomiting if swallowed. Contact Physician and seek medical attention immediately. KEEP OUT OF THE REACH OF CHILDREN. DOT (Proper Shipping Name) Flammable Liquid N.O.S. (Toluene, Mineral Spirits), 3, UN, PG II.
MATERIAL SAFETY DATA SHEET 1. Product and Company Identification Material name Self Strip Liquid Version # 01 Revision date Product use Mold Release. Manufacturer/Supplier TR Industries Vulcan Street. TR INDUSTRIES Vulcan Street South Gate, CA Phone • Fax RELEASES COMPOUNDS POLISHES TR SELF-STRIPPING LIQUID MOLD RELEASE DESCRIPTION: TR is a liquid wax release based on our CARNAUBA base Paste Wax and blend of active cleaning solvents to reduce and minimize styrene and wax release build-up or accumulation.
TR Self Stripping Liquid Release Wax A high production liquid mould release formulated to reduce or eliminate styrene, wax build up problems in the cultured marble and . Be aware that the liquid may penetrate the gloves. Frequent change is advisable. Other Wear suitable protective clothing. Self Strip Liquid SDS US Version #: 02 Revision date: June Issue date: April 4 /
Less volatile than TR Self Stripping Liquid Mold Release. Tr Regular Liquid Mold Release is a thin, effective release for non-skid, sandblasted, knurled or grained surfaces. Eliminates paste build-up. Rapid settling of liquid waxes requires shaking well before and during use. Liquid mold release is recommended for use on fully cured. TR produces a lustrous high-gloss finish and sure positive releases. Reduced mold prep time, elimination of wax buildup and extended mold life are ways TR liquid release improves efficiency. Liquid mold release is recommended for use on fully cured, well-conditioned mold only.